No text or picture Add-ons were added yet. How sad!
Here is what you need; a high temperature hot glue gun, a pair of wire nippers, and several bunches of foliage with berries.
And then what you need to do is take the wire nippers and cut off each leaf, if you want the small ones and the large ones. You will need the smaller ones for the tips of the trees and larger ones in the middle and bottom.
Here are the three different sides as I had ended it up with. And then I spray pitted tree tear cut apart with the metallic spray paint. Then take a bit of glue and run it along the base of the cone. If you want to use the really hot glue gun temperature setting so that it will stick really well and then just place it in the pot, make sure it is straight and then put a little beads of glue around the base again of the cone, and then place each leaf one by one along the glue and you may need to use a glass to press over because the glue gets kind of hot.
Just continue this all the way around and up the cone until there is no cone showing. Be sure to use this smaller leaves at the top and the larger leaves in the middle and on the bottom. Then place a little glue on each of the holy berries or the leaves and then stick the holy berries in the glue and then press down and hold it until it dries. You can just do that kind of sporadically around the tree just enough to make it look nice and you can add a little section of holy berries at the top on each tree.
And there you have it, three beautiful Christmas Topiaries.
Transcription by:
Scribe4you Transcription Services