So, what we have got now, we have got this guy her, okay and we have got this black piece here that is sits on there like so. So, we line up the screws and theoretically we should be able to press it in, like so. Now then, the reason possibly, again possibly that this guy here was loose is because these screws, one of them might have just got a tiny bit loose over a period of time. Now then, right. Now, this is where you need to be careful, now then I have got here one of these guys, alright. Now, I suggest to highly recommend you do not use an electric screw driver, there is a very, very good reason and that is an electric screw driver has got a lot more power than you have got.
Now, you know when you are screwing this screws in, you will know when it is starting to get tight but if you do not set the electric screw driver correctly then what will happen is you could screw them down to tight and then there is going to be an absolute nightmare to get back in or out should I say. What you need to do is again you do not need to go to all this procedure of getting all of this software or whatever, I am just showing you that but what you need to do is check one, two, three screws, okay. Make sure that they are tight, okay and you will know if their tight because this guy here in the middle should not be able to move, right.
If you watch and I, if I put a bit of pressure down there, like so, okay, you can see that is pretty solid but if I let go, I take the pressure away, you can see that is moving it, that is not going that much movement. We already talking about a tiny fraction but if you think about it, if you got a millimeter or even half of millimeter movement here, the 30 you go out the more the movement is going to be. What you have to bare in mind is the distance between this area here and the base of the actual platter is very, very minimum, okay.
What you have to consider is this, while you have the lit of the platter that is fits to almost it is really, so almost it is turning neck continually. Now, you do not want that to do, to stop banging there and of course the trouble is you see over a period of time with all ten tables is again, if I just come out a tiny bit, right. If you put that on put knock here, I should not put all in neck because it is not screw down, is it. Okay, alright, let just move the camera, like that.
Now then, if you think about it, alright, say you imagine now the platter in on the turn table and as DJs you put your hand here on the record and you actually having a tiny bit of pressure continually there. Now, over a period of time when you are having pressure that all the time something is going to give, eventually something is going to give. Possibly that is something to look at when buying on turn table, alright. Right, bare in mind the hope that is been a help and also a small video but you never know it could help one or few people at that.
Thanks for watching practice and enjoy.
Transcription by:
Scribe4you Transcription Services