BMP Design E46 Front Spoiler Installation
www.bmpdesign.com
Male Speaker: Okay. The project is going to be installing this lower dynamics spoiler to an E46. Basically what you will do is you will install a little bit, you will put a little bit of 3M adhesive in this area right here, on both sides. The spoiler will come through like this. You will set it down on that lift, line up your edges with the parting line right on the edge of the bumper.
It's angled upward at the moment. You bring it in as far as you can, and then what you will do is roll the nose of the bumper down, the nose of the spoiler down, and it will latch into the corners. One side is complete, other side is complete.
Final installation will include some sheet metal screws, if you select in the corners. So you will have adhesion here, you will have adhesion here, and then in the far corner, you will just put small sheet metal screw that attaches it to the bumper.
Finally, to close this parting line, you can use pure silicon, put a little bit down in the groove, wipe it clean when it's still in the wet mode, and then you will be finished.
For more information please visit their website: http://www.bmpdesign.com
Transcription by:
Scribe4you Transcription Services