How to Make BNC mini Hi-Res cable

PUTTING A MINI BNC RCBHV CONNECTORS AND 5 WIRE CABLE TOGETHER Autonomy of the BNC connector [Demo] • BNC • PIN • Ferrel • SPACER STEP 1 [Demo] • REMOVE THE JACKET • REMOVE RIPPCORD AND STUFFING • STEP 2 • HEAT SHRINK 2 in L 3/4 W Single Wall Black Shrink [Demo] • APPLY HEAT ½ OVER JACKET ½ OVER THE WIRES [Demo] ¼ in W 2 in L SINGLE WALL SHRINK HORIZONAL VERTICAL [Demo] PLACE A TIE WRAP AROUND WIRE DON’T TIGHTEN TOO TIGHT STEP 3 • MAKE THE CONDUCTOR TO CONNECTOR CONNECTION [Demo] • PLACE THE FERREL OVER THE WIRE • THE TIE WRAP KEEPS THE FERREL FROM SLIDING INTO THE SHRINK AND KEEPS THE SHRINK FROM FALLING OF THE WIRE • STRIP BACK THE AJCKET EXPOSING THE SHIELD AND THE INSULATOR • REMOVE ENOUGH JACKET SO THAT THE INSULATOR IS LONGER THAT THE STIFFENER • TWIST TOGETHER THE SHIELD AND REMOVE ANY EXCESS PAPER • PLACE THE SPACER OVER THE INSULATOR • STIRP THE INSULATOR EXPOSING THE CONDUCTOR • PLACE THE CONDUCTOR INSIDE THE PIN • MAKE SURE THAT ALL OF THE CONDUCTOR IS INSIDE THE PIN NO STRANDS STICKING OUT!!! • USE THE CRIMP TOOL TO SECURE THE PIN TO THE CONDUCTOR • CLOSE THE CRIMPERS JUST ENOUGH TO GET THE PIN INTO THE SLOT • MAKE SURE TO PLACE THE PIN IN THE CORRECT SLOT AND IN THE CORRECT ORIENTATION • PLACE THE PIN INSIDE THE BNC • TIRM DOWN THE SHIELD SO THAT WHEN YOU MOVE THE FERREL NO STRANDS WILL SHOW BUT KEEP IT LONG ENOUGH TO MAKE GOOD CONTACT • SLIDE THE FERREL SNUG TO THE BNC • NO STRANDS!!!!!!!! • RUN THE TIP OF YOUR FINGER OVER THE BNC TO CHECK THE SEATING OF THE PIN IF YOU FEEL IT THEN IT'S GOOD TO GO • INSERT THE BNC INTO THE CRIMPER PLACE THE FERREL INTO THE SLOT • USE YOUR FINGER TO REMOVE THE BNC STEP 4 • FINISH THE SHRINK [Demo] STEP 5 • REPEAT 4 MORE TIMES THE FINAL PRODUCT [Demo] FOX IN THE BOX