The HomeServe guide to stopping squeaky hinges.
It is enough to drive you crazy, that little squeak every time you open the door or the cupboard but it is so simple to fix in really no time at all, let Homeserve tell you how:
WD-40 is a widely used lubricating oil that is perfect for this job. Spray it right onto the hinge then open and close the door a few times and it will start to do the trick almost immediately.
Top Tip: Use the straw provided to stop the oil going everywhere as it can stain. If you do not have any WD-40 handy, you can try motor or even cooking oil, although the effects of these won't last as long.
Wire wool: If your hinge is still squeaky, remove it completely from the door and slide out the hinge pin. Give it a good rub with wire wool, this will remove any dirt or rust which might be causing the squeak. Then replace it back on the door and re-spray with WD-40 or oil.
Soap: Another very simple solution is to take the hinge pin out and rub with a bar of soap. Replace the hinge and open and close the door a couple of times to allow for the soap to spread through the mechanism.
Replace the hinge: If the worst comes to the worst and you cannot get rid of the squeak, chuck the hinge out and pop down to your local DIY store to find a good replacement.
If you are struggling replacing the hinge or with any of the teccy bits why not give Homeserve a call and they can come and give a helping hand.
No more squeaks. Another job well done.
Transcription by:
Scribe4you Transcription Services