We would together see all way the around. Now, we had to have a mouth so with the mouth pattern and I got the mouth pattern that I will include but she need to know what to do like I said, they are just a pattern and not direction. The first thing you are going to need is a piece of cardboard and so here is where we use. I already cut from the pattern, I cut a piece of strong cardboard that is going to fit in the mouth, and we need to score, that is why we need the ruler. Score means, it is mark on the pattern that we are to do it and then run a pen back and forth and back and forth and back in two spot, it shows you where. So that it will bend and with a little crease in the back I have it already. Again, I line things so that it will last a lot longer. I have already covered that with some materials so that you could use a lot of different things.
Now, what we are going to do next is put the top of the foam puppet in place. Now, you can line this two if you want to. On the top of the mouth, now take some tacky glue and put it around the edge. Just check and hit the glue and then put it around the edge because we are going to make a little top pocket. Remember that this part is the upper part of the mouth and you want to leave a little pocket underneath so your hand can go inside and the same thing with the body, if you want to line it, fine. Again, with another piece of cloth and then glue around the outside, so we have a pocket again like that.
Now, this one already has the red mouth and usually, we do not put the red mouth until later. Because we will show you how that goes together and this is the basis, for all the enamel patterns, the mouth patterns. Because it is a stuff toy puppet in a different program that we measure them and cut a brief type of a mouth pattern with each individual puppet with it. Now we have to put the mouth. You can use half-inch foam or inch foam in the mouth. We have to put that remember that part is fixed at the top with a little pocket inside and the clock and remember this is the back part of the puppet that makes it go.
Just allow the mouth to open. With the top, I am going to put it in like a little sandwich inside of the mouth. Then we hot glue it again. Hot glue gun and foam go together all the way around that mouth until it looks like a top. This one does not have a red on it yet. Now this has all hot glue gun I think I use contact on that originally. Then the next step is to make the cloth covering. What you want to do is take that same pattern that I sent to you or we will send you and paint it on a piece of cloth. Deliver inside the double piece pulled it over, and pin to the outside. You are going to saw.
Transcription by:
Scribe4you Transcription Services