I am Mark Erickson and this is Infinite Solutions. Don't you hate it when you go to use a flashlight or a TOS Phaser only to find they have dead batteries. You replace them, but you can't find the type you need, be it AA or D cell. In this episode, I am going to show you how to use charged alkaline batteries of an undesired type to recharge dead batteries and the size you need.
Electric currents run from anode to cathode. That's why batteries are arranged with their opposite poles adjacent. On items that have inverted batteries, their orientation is on a kind of interior wiring that's serves to connect the batteries in the way I have just described. That's why you never see a portable gaming system or a remote with double AA is running parallel, but if you invert the batteries, so their positive terminals are connected, capacitance from the charged battery will flow into the uncharged one. The trick is to get the opposite magnitudes so the transfer can take place and to do that you need to know the impedance ratios. For instance, two double AA equals one C meaning two AA can recharge one C battery. Orient them as shown here and secure with electrical tape. It's called electrical tape because it conducts electricity. Leave them for approximately 24 hours. The charge will flow from the C battery into the AA until the counter full of capacitance equalizes. At this point, all batteries will be charged equally. You can then replace any or all batteries on one side of the equation to repeat the procedure and reach on the opposite side further. A dead battery can never be fully recharged.
To reduce charging time, you can apply the acidic catalyst at the terminals beforehand. This speeds the chemical reaction. This works with any battery type. Pause the screen if you need to. Nine volts are tricky to orient because both terminals are on the same side. I hope you found this interesting. I am Mark Erickson and this is Infinite Solutions.
Transcription by:
Scribe4you Transcription Services