[Music playing]
And hello, I am Johnny Fleishmann, on today’s video tutorial are—only tutorial, we will be showing you, the viewer, how to make an intriguing device called the “Snory Cam” defined as an incomparable device created by Requiem for a Dreams Director Darren Aronofsky to be worn round the abdomen thus creating a unique and innovated new camera angle.
[Trailer]
[Sound effects]
[Trailer]
This robe was worn by Brad Pitt in David Fincher’s fight club. Now, let us travel down to the workshop to see how we built this thing.
[Music playing]
We usually need—why uncover these traps?
[Music Playing]
Now that we are in a workshop we have to gather all our tools.
This list includes a hammer, a handsaw, or a jigsaw, screws, a screwdriver, foot long nylon straps, wood. How much would you ask? A lot. Go to our address for more information. www.quickfile.com/C0907, and finally one 20 inch bungee cord. And now let us start assembling. We are going to go from top to bottom, from your wood supply; you are going to need to cut off a nine by five and a half inch board for the platform of your camera.
If you look closely, there is a screw right in the middle of the board to help stabilize your camera. You can accomplish this by using drill bit to drill a hole into your platform depending on how big the head of your screw is. Moving down the line, the shaft is probably the hardest part to build.
To build the shaft you are going to need to cut off three feet from your supply of wood. Then you are going to have to cut the right angles to make your platform and then you use a jigsaw to cut off the curve piece.
And lastly, cut the other end a little less extreme so that it can attach to the platform that goes to the abdomen.
For the final part, you are going to use three screws and your bungee cord to attach it to the platform.
Next, use your two nylon straps and screw them on the opposite end of the same board that you attach the bungee cord to.
And one of the last steps is to attach those same nylon straps to a separate board thirteen inches long.
In your final step, screw two screws on opposite ends of the same board to attach the bungee cord to.
Did not quite catch all that? We will help you out a little bit. To put it on you can put the nylon straps over the head, make sure that your back piece is pressed against the back then, grabs a bungee cords on each side, pass them around and hook them to the nails. Next, you are going to take the other side of the bungee and attach it the screw on the other side.
Moving to the front, you are going to want your chest piece pressed against your chest, firmly screwed into your shaft, which moves up, which is attach to the platform of your camera, which contains the bolt that we have talked earlier. And lastly you are going to attach your camera to the “Snory Cam.” You are going to do this by using the bolt and screw it into the bottom of your camera.
This concludes our video tutorial of the “Snory cam”.
And if you have any questions do not be shy to ask. You can email us at this email address--
Or this one--
And if you want to check out any of our other videos or the full diagram of the Snory Cam check out this two addresses--
On behalf of the whole crew, I am John Fleishmann, and I am Mark Madness. And it has been fun. Fleishmann
Way too much fun!
Transcription by:
Scribe4you Transcription Services